Velodyne DIGITAL DRIVE SMS-1 Betriebsanleitung PDF herunterladen (Seite 26)

26THE OUTLAW’S GUIDE TO THE SMS-1

TABLE: RS232 COMMANDS

Acceptable ‘n’

Function Command Format Input Values Examples Remarks

Volume Control #VOnn$, #VO+$, 00-99 #VO09$ Use ‘nn’ values to set a specic volume,

#VO-$, #VO?$ #VO57$ raise or lower the volume one increment,

#VO+$ or request the current volume level.

#VO-$

#VO?$

Preset Control #PSn$, #PS?$ 1, 2, 3, 4, 5, 6 #PS5$ Select a preset or request the current

#PS?$ active preset.

Front Panel #LTn$, #LT?$ 0: Light O #LT0$

Light Control 1: Light On #LT1$ Turn the front panel display light on and

#LT?$ o, or request the light status.

Night Mode Control #NMn$, #NM?$ 0: Night Mode O #NM0$ Turn night mode on and o, or request

1: Night Mode On #NM1$ night mode status.

#NM?$

Mute Control #MUn$, #MU?$ 0: Mute O #MU1$ Turn mute on and o, or request mute

1: Mute On #MU?$ status.

Power Control #JUn$, #JU?$ 0: Power O #JU0$ Turn SMS1 power on and o, or request

1: Power On #JU1$ power status.

#JU?$

SPECIAL REMOTE CODES

Many of the features that we have discussed are activated using special

commands or strings of commands from the remote control.

Since it can be handy to have all of those commands gathered in a single

place, we have done just that below.

TABLE: SPECIAL REMOTE CODES

Function Command Code Remarks

Main Menu 1-2-3-4-5 Enters Main Menu. Can also be achieved by pressing MENU

followed by 1-2-3-4-5.

Self EQ 3-2-1 Activate Self EQ mode. Make sure the microphone is connected

before entering the command. Press RESET to cancel Self EQ.

Restore Factory Defaults 8-9-0 Restore all settings to factory defaults and reset the SMS1.

Switch Video to DOWN ARROW: 4 times This command resets the unit; upon restarting, the video output is in

PAL/SECAM RESET PAL/SECAM format. To return to the standard NTSC video output,

restore the factory defaults.

Display Serial Number UP ARROW: 4 times This command will cause the unit to display the serial number

SELECT at the top of the Introductory Screen.

Restore Saved RESET The volume level is saved along with the other settings when

Volume Level exiting the menus. Pressing RESET will cause the volume to revert

to that volume setting.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

Velodyne DIGITAL DRIVE SMS-1 Betriebsanleitung Seite 26